Fiat Linea Manuel d'utilisateur télécharger pdf (Page 64)

63

SAFETY

DEVICES

CORRECT USE

OF THE

CAR

WARNING

LIGHTS AND

MESSAGES

IN AN

EMERGENCY

CAR

MAINTENANCE

TECHNICAL

SPECIFICATIONS

INDEX

DASHBOARD

AND CONTROLS

Fan speed adjusting buttons (H)

Press button H to increase or to decrease

the fan speed and therefore the amount

of air admitted into the passenger com-

partment, although keeping the required

temperature set.

The fan speed is shown by the lit bars on

the display:

❒

max fan speed = all bars lit;

❒

min fan speed = one bar lit.

The fan can be cut off only if the climate

control compressor has been switched

off pressing button F-fig. 40.

IMPORTANT To restore automatic fan

speed control after a manual adjustment,

press button AUTO.

IMPORTANT At high speeds, the dynamic

effect may increase the flow of air into the

passenger compartment which in this case

will not directly correspond to the fan

speed bar display.

AUTO (A) (automatic operation)

Press AUTO to make the system auto-

matically adjust the quantity and distribu-

tion of the air introduced into the pas-

senger compartment. All previous manu-

al settings will be cancelled.

The message FULL AUTO will appear

on the front display in this condition.

By manually intervening on at least of the

functions automatically managed by the

system (air recirculation, fan speed or

compressor on/off), the word FULL will

disappear from the display indicating that

the system is no longer automatically con-

trolling all the functions (the temperature

will still be controlled automatically by the

system).

IMPORTANT Should the system (after

manual settings) be no longer able to

guarantee the required temperature set

in the passenger compartment, the set

temperature value will start flashing to in-

dicate this condition, after one minute the

AUTO message will turn off.

To restore system automatic control at

any time, after one or more manual ad-

justments, press button AUTO.

Air recirculation on/off button (G)

Air recirculation works according to the

following operating logics:

❒

override on (inside air recirculation

always on), indicated by the the LED

on button G and symbol T on

the display;

❒

override off (air recirculation always

off and introduction of external air),

indicated by the fact that the LED on

the button is off êis on the display.

These operating conditions are obtained

by pressing G in sequence.

IMPORTANT The inside air recircula-

tion system makes it possible to reach

the required heating or cooling condi-

tions faster.

It is however inadvisable to use it on

rainy/cold days as it would considerably

increase the possibility of the windows

misting inside, especially if the climate

control compressor is off.

Recirculation is forced off (i.e. air is

introduced from the outside) when the

the outside temperature is cold to pre-

vent misting up.

It is advisable not to use the air recircu-

lation function when the outside tem-

perature is low to prevent the windows

from rapidly misting up.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 229 230

Commentaires sur ces manuels

Pas de commentaire